Dell 9.8(0.0) Network Router User Manual


  Open as PDF
of 1910
 
permit — configures a permit filter.
ip access-list standard
Create a standard IP access list (IP ACL) to filter based on IP address.
Syntax
ip access-list standard access-list-name
To delete an access list, use the no ip access-list standard access-
list-name command.
Parameters
access-list-
name
Enter a string up to 140 characters long as the ACL name.
Defaults All IP access lists contain an implicit “deny any,” that is, if no match occurs, the
packet is dropped.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Increased the name string to accept up to 140 characters.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Added support for the non-contiguous mask and added the
monitor option.
6.5.1.0 Expanded to include the optional QoS order priority for the
ACL entry.
Usage
Information
Dell Networking OS supports one ingress and one egress IP ACL per interface.
Prior to Dell Networking OS version 7.8.1.0, names are up to 16 characters long.
232
Access Control Lists (ACL)