Filter
Top Products
To use the switchport backup interface command on a port, first enter the
switchport command. For more information, refer to the “Configuring
Redundant Links” section in the “Layer 2” chapter of the
Dell Networking OS
Configuration Guide.
Egress Interface Selection (EIS) Commands
The following commands are Egress Interface Selection (EIS) commands.
application
Configure the management egress interface selection.
S4820T
Syntax
application {all | application-type}
To remove a management application configuration, use the no application
{all |
application-type} command.
Parameters
application-
type
Enter any of the following keywords:
• For DNS, enter the keyword dns.
• For FTP, enter the keyword ftp.
• For NTP, enter the keyword ntp.
• For Radius, enter the keyword radius.
• For sFlow collectors, enter the keyword sflow-
collector.
• For SNMP (traps and MIB responses), enter the keywords
snmp .
• For SSH, enter the keyword ssh .
• For Syslog, enter the keyword syslog.
• For TACACS, enter the keyword tacacs.
• For Telnet, enter the keyword telnet.
• For TFTP, enter the keyword tftp.
all Configure all applications.
Defaults None.
Command
Modes
EIS Mode (conf-mgmt-eis)
Interfaces
855