Filter
Top Products
router isis
Allows you to enable the IS-IS routing protocol and to specify an IP IS-IS process.
S4820T
Syntax
router isis [vrf vrf-name] [tag]
To disable IS-IS routing, use the no router isis [tag] command.
Parameters
vrf vrf-name Enter the keyword vrf followed by the name of the VRF to
enable the IS-IS routing protocol and to specify an IP IS-IS
process on that VRF.
tag (OPTIONAL) This is a unique name for a routing process. A
null tag is assumed if the tag option is not specified. The tag
name must be unique for all IP router processes for a given
router.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
Usage
Information
Configure a network entity title (the net command) to specify the area address and
the router system ID.
Enable routing on one or more interfaces to establish adjacencies and establish
dynamic routing.
You can configure only one IS-IS routing process to perform Level 2 routing. A
level-1-2 designation performs Level 1 and Level 2 routing at the same time.
Intermediate System to Intermediate System (IS-IS)
1079