Filter
Top Products
security-name
name
(Optional) Enter the keywords security-name then the
security name as defined by the community MIB.
access-list-
name
(Optional) Enter a standard IPv4 access list name (a string up
to 16 characters long).
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage
Information
The following example configures a community named public that is mapped to
the security named guestuser with Read Only (ro) permissions.
The security-name parameter maps the community string to an SNMPv3 user/
security name as defined by the community MIB.
If a community string is configured without a security-name (for example,
snmp-server community public ro), the community is mapped to a default
security-name/group:
• v1v2creadu / v1v2creadg — maps to a community with ro (read-only)
permissions.
• v1v2cwriteu/ v1v2cwriteg — maps to a community with rw (read-write)
permissions.
The community-name parameter indexes this command.
If you do not configure the snmp-server community command, you cannot
query SNMP data. Only Standard IPv4 ACL and IPv6 ACL is supported in the
optional
access-list-name.
The command options ipv6, security-name, and access-list-name are
recursive. In other words, each option can, in turn, accept any of the three options
1698
Simple Network Management Protocol (SNMP) and Syslog