Dell 9.8(0.0) Network Router User Manual


  Open as PDF
of 1910
 
Field Description
PEER RPM Status Displays the state of the second RPM, if present
RPM Redundancy
Configuration
Displays the following information:
which RPM is the preferred Primary on next boot (the
redundancy primary command)
the data sync method configured (the redundancy
synchronize
command)
the failover type (you cannot change this type; it is
software-dependent). Hot Failover means that the
running configuration and routing table are applied on
secondary RPM. Fast Failover means that the running
configuration is not applied on the secondary RPM until
failover occurs, and the routing table on line cards is
cleared during failover.
the status of auto booting the RPM (the redundancy
disable-auto-reboot
command)
the parameter for auto failover limit control (the
redundancy auto-failover-limit command)
RPM Failover
Record
Displays the following information:
RPM failover counter (to reset the counter, use the
redundancy reset-counter command)
the time and date of the last RPM failover
the reason for the last RPM failover
Last Data Sync
Record
Displays the data sync information and the timestamp for
the data sync:
Start-up Config is the contents of the startup-config file.
Line Card Config is the line card types configured and
interfaces on those line cards.
Runtime Event Log is the contents of the Event log.
Running Config is the current running-config.
This field only appears when you enter the command from
the Primary RPM.
Example
(S4820T)
Dell#show redundancy
-- Stack-unit Status --
------------------------------------------------
Mgmt ID: 0
Stack-unit ID: 0
Stack-unit Redundancy Role: Primary
Stack-unit State: Active
Stack-unit SW Version: FIT-R2D2-1-0-0-89
Link to Peer: Down
Peer Stack-unit: not present
-- Stack-unit Redundancy Configuration --
756
High Availability (HA)