Filter
Top Products
Version Description
8.4.1.0 Added support for IPv4 multicast and IPv6 unicast routes.
7.8.1.0 Introduced on the S4810.
7.7.1.0 Introduced on the C-Series.
7.2.1.0 Introduced on the E-Series TeraScale.
Usage
Information
This command turns on BGP soft-reconfiguration inbound debugging for IPv6
unicast routes. If no neighbor is specified, debug is turned on for all neighbors.
ipv6 prefix-list
Configure an IPv6 prefix list.
S4820T
Syntax
ipv6 prefix-list prefix-list name
Parameters
prefix-list name Enter the name of the prefix list.
NOTE: There is a 140-character limit for prefix list
names.
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant FTOS Command Line Reference Guide.
The following is a list of the FTOS version history for this command.
Version Description
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.10.0 Introduced on the S4810.
neighbor soft-reconfiguration inbound
Enable a BGP soft-reconfiguration and start storing updates for inbound IPv6 unicast routes.
S4820T
Syntax
neighbor {ipv4-address | ipv6-address | peer-group-name} soft-
reconfiguration inbound
536
Border Gateway Protocol