Filter
Top Products
Example (Single
Range)
This example shows how to define an interface range macro named test. Execute
the show running-config command to display the macro definition.
Dell(config)# define interface-range test tengigabitethernet
1/1 -3,
tengigabitethernet 5/1 -47, tengigabitethernet 13/1 -89
Dell# show running-config | grep define
define interface-range test tengigabitethernet 1/1 -3,
tengigabitethernet 5/1 -47,
tengigabitethernet 13/1 - 89
Dell(config)#interface range macro test
Dell(config-if-range-te-1/1-3,te-5/1-47,te-13/1-89)#
Related
Commands
interface range – configures a range of command (bulk configuration)
interface range macro name – runs an interface range macro.
interface range macro name
Run the interface-range macro to automatically configure the pre-defined range of interfaces.
S4820T
Syntax
interface range macro name
Parameters
name Enter the name of an existing macro.
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Interfaces
809