Filter
Top Products
To place no limit on the number of fragments allowed, use the no ip max-frag-
count command.
Parameters
count Enter a number for the number of fragments allowed for re-
assembly. The range is from 2 to 256.
Defaults No limit is set on number of fragments allowed.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced for the E-Series.
Usage
Information
To avoid denial of service (DOS) attacks, keep the number of fragments allowed for
re-assembly low.
ip max-routes
Enables you to configure the maximum number of protocol routes per VRF that are allowed for IPv4.
S4820T
Syntax
ip max-routes [vrf vrf-name] max-number
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF for
which you want to configure maximum number of protocol
routes that IPv4 allows.
IPv4 Routing
921