Filter
Top Products
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.1.1.0 Introduced on the E-Series ExaScale.
7.9.1.0 Introduced VRF on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage
Information
This command provides egress port information for a given IP flow. This
information is useful in identifying which interface the packet follows in the case of
Port-channel and Equal Cost Multi Paths. Use this command for routed packed
only. For switched packets, use the show port-channel-flow command.
The show ip flow command does not compute the egress port information
when
load-balance mac hashing is also configured due to insufficient
information (the egress MAC is not available).
S-Series produces the following error message: %Error: Unable to read IP
route table
.
Example
Dell#show ip flow interface te 2/42 20.1.1.1 100.1.1.2
protocol tcp
Flow: 20.1.1.1 100.1.1.2 6
Ingress interface: Te 2/42
Egress Interface: Te 2/43
Dell#
show ip interface
View IP-related information on all interfaces.
S4820T
Syntax
show ip interface [interface | brief] [configured]
954
IPv4 Routing