Filter
Top Products
31
Link Aggregation Control Protocol (LACP)
This chapter contains commands for Dell Networks’s implementation of the link aggregation control
protocol (LACP) for creating dynamic link aggregation groups (LAGs) — known as “port-channels” in the
Dell Networking operating software. The LACP commands in this chapter are supported by Dell
Networking OS on the S4820T platform.
NOTE: For static LAG commands, refer to Port Channel Commands in the Interfaces chapter),
based on the standards specified in the IEEE 802.3 Carrier sense multiple access with collision
detection (CSMA/CD) access method and physical layer specifications.
clear lacp counters
Clear port channel counters.
S4820T
Syntax
clear lacp port-channel-number counters
Parameters
port-channel-
number
Enter a port-channel number. The range is from 1 to 128.
Defaults Without a Port Channel specified, the command clears all Port Channel counters.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
1096
Link Aggregation Control Protocol (LACP)