Filter
Top Products
l2qos number Enter the keyword l2qos and then the number of FP blocks
for l2 qos. The range is from 1to 8.
l2pt number Enter the keyword l2pt and then the number of FP blocks
for l2 protocol tunnelling. The range is from 0 to 1.
Ipmacacl
number
Enter the keyword ipmacacl and then the number of FP
blocks for IP and MAC ACL. The range is from 0 to 6.
ecfmacl
number
Enter the keyword ecfmacacl and then the number of FP
blocks for ECFM ACL. The range is from 0 to 5.
nlbclusteracl
number
Enter the keyword nlbclusteracl and then the number of
FP blocks for nlbcluster ACL. The range is from 0 to 2. By
default the value is 0 and it supports 8 NLB arp entries
reserved for internal functionality.
NOTE: When you reconfigure CAM allocation, use the
nlbclusteracl number command to change the
number of NLB ARP entries. The range is from 0 to 2.
The default value is 0. At the default value of 0, eight NLB
ARP entries are available for use. This platform supports
up to 512 CAM entries. Select 1 to configure 256 entries.
Select 2 to configure 512 entries. Even though you can
perform CAM carving to allocate the maximum number
of NLB entries, Dell Networking recommends that you
use a maximum of 64 NLB ARP entries.
Vman-qos|
vman-dual-qos
number
Enter the keyword evman-qos and then the number of FP
blocks for VMAN QoS. The range is from 0 to 6.
vman-dual-qos
number
Enter the keyword vman-dual-qos and then the number of
FP blocks for VMAN dual QoS. The range is from 0 to 4.
Ipv4pbr
number
Enter the keyword ipv4pbr and then the number of FP
blocks for ipv4pbr ACL. The range is from 0 to 8.
Openflow
number
Enter the keyword openflow and then the number of FP
blocks for open flow (multiples of 4). The range is from 0 to
8.
fcoeacl
number
Enter the keyword fcoeacl and then the number of FP
blocks for FCOE ACL. The range is from 0 to 6.
Iscsioptacl
number
Enter the keyword iscsioptacl and then the number of FP
blocks for iSCSI optimization ACL. The range is from 0 to 2.
vrfv4acl
number
Enter the keyword vrfv4acl and then the number of FP
blocks for VRF IPv4 ACL. The range is from 0 to 2.
Content Addressable Memory (CAM)
541