Filter
Top Products
Default Disabled
Command
Modes
INTERFACE (management interface only)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.1.(0.0) Updated Usage Information section.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
Usage
Infomation
• SAA can configure up to two addresses. If any preferred prefix or valid timers
time out, the corresponding address are deprecated or removed. If an address
is removed due to a time-out, an address from the current unused prefix is used
to create a new address. If there are no remaining prefixes, the software waits
to receive a new prefix from the RA.
• If auto-configuration is enabled, all IPv6 addresses on that management
interface are auto-configured. Manual and auto-configurations are not
supported on a single management interface.
• Removing auto-configuration removes all auto-configured IPv6 addresses and
the link-local IPv6 address from that management interface.
• IPv6 addresses on a single management interface cannot be members of the
same subnet.
• IPv6 secondary addresses on management interfaces across a platform must be
members of the same subnet.
• IPv6 secondary addresses on management interfaces should not match the
virtual IP address and should not be in the same subnet as the virtual IP.
ipv6 address
Configure an IPv6 address to an interface.
S4820T
Syntax
ipv6 address {ipv6-address prefix-length}
To remove the IPv6 address, use the no ipv6 address {ipv6-address
prefix-length
} command.
IPv6 Basics
989