Filter
Top Products
Version Description
6.2.1.1 Introduced on the E-Series.
Usage
Information
When you enable debug spanning-tree bpdu for multiple interfaces, the
software only sends information on BPDUs for the last interface specified.
Related
Commands
protocol spanning-tree — enters SPANNING TREE mode on the switch.
description
Enter a description of the spanning tree.
Syntax
description {description}
To remove the description from the spanning tree, use the no description
{description} command.
Parameters
description Enter a description to identify the spanning tree (80
characters maximum).
Defaults none
Command
Modes
SPANNING TREE (The prompt is “config-stp”.)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced
Related
Commands
protocol spanning-tree — enters SPANNING TREE mode on the switch.
1772
Spanning Tree Protocol (STP)