Filter
Top Products
Version Description
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
7.5.1.0 Added support for LSP Throttling Enhancement.
Usage
Information
The link MTU and the LSP MTU size must be the same.
Because each device can generate a maximum of 255 LSPs, consider carefully
whether you use the lsp-mtu command.
lsp-refresh-interval
Set the link state PDU (LSP) refresh interval. LSPs must be refreshed before they expire. When the LSPs are
not refreshed after a refresh interval, they are kept in a database until their
max-lsp-lifetime reaches
zero and then LSPs is purged.
Syntax
lsp-refresh-interval seconds
To restore the default refresh interval, use the no lsp-refresh-interval
command.
Parameters
seconds The LSP refresh interval, in seconds. This value must be 300
seconds less than the value specified in the max-lsp-
lifetime command. The range is from 1 to 65535 seconds.
The default is
900.
Defaults 900 seconds
Command
Modes
ROUTER ISIS
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
1066
Intermediate System to Intermediate System (IS-IS)