Filter
Top Products
Version Description
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names are up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Related
Commands
match interface — redistributes routes that match the next-hop interface.
match ip next-hop — redistributes routes that match the next-hop IP address.
match ip route-source — redistributes routes that match routes advertised by other
routers.
match metric — redistributes routes that match a specific metric.
match route-type — redistributes routes that match a route type.
match tag — redistributes routes that match a specific tag.
match ip next-hop
To match based on the next-hop IP addresses specified in an IP access list or IP prefix list, configure a
filter.
Syntax
match ip next-hop {prefix-list prefix-list-name}
To delete a match, use the no match ip next-hop {prefix-list prefix-
list-name
} command.
Parameters
prefix-list
prefix-list-
name
Enter the keywords prefix-list and then enter the name
of configured prefix list, up 10 140 characters.
Defaults Not configured.
Command
Modes
ROUTE-MAP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Access Control Lists (ACL)
297