Filter
Top Products
neighbor remote-as
Create and specify the remote peer to the BGP neighbor.
S4820T
Syntax
neighbor {ip-address | peer-group-name} remote-as number
To delete a remote AS entry, use the no neighbor {ip-address | peer-
group-name} remote-as number command.
Parameters
ip-address Enter the IP address of the neighbor to enter the remote AS
in its routing table.
peer-group-
name
Enter the name of the peer group to enter the remote AS
into routing tables of all routers within the peer group.
number Enter a number of the AS. The range is from 0 to 65535 (2
byte) or from 1 to 4294967295 (4 byte).
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series. Added 4-byte support.
Usage
Information
To accept 4-byte formats before entering a 4 byte AS Number, configure your
system. If the number parameter is the same as the AS number used in the router
bgp
command, the remote AS entry in the neighbor is considered an internal BGP
peer entry.
This command creates a peer and the newly created peer is disabled (Shutdown).
This command automatically restarts the neighbor session for the configuration to
take effect.
Border Gateway Protocol
463