Filter
Top Products
rp2 (OPTIONAL) Enter the keyword rp2 to view only the
statistics from Route Processor 2.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.5.1.0 F10 Monitoring MIB available for the ip traffic
statistics command.
pre-6.1.1.0 Introduced on the E-Series.
Usage
Information
The following describes the show ip traffic summary shown in the following
example.
Keyword Definition
unknown
protocol...
No receiver for these packets. Counts packets whose
protocol type field is not recognized by Dell Networking OS.
not a gateway... Packets can not be routed; the host/network is unreachable.
security failures... Counts the number of received unicast/multicast packets
that could not be forwarded due to:
• route not found for unicast/multicast; ingress interfaces
do not belong to the destination multicast group
• destination IP address belongs to reserved prefixes; the
host/network is unreachable
bad options... Unrecognized IP option on a received packet.
Frags: IP fragments received.
... reassembled Number of IP fragments that were reassembled.
IPv4 Routing
969