Filter
Top Products
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced.
Usage
Information
In Dell Networking OS versions prior to 8.3.1.0, if a gratuitous ARP is received some
time after an ARP request is sent, only RP2 installs the ARP information. For
example:
1. At time t=0, Dell Networking OS sends an ARP request for IP A.B.C.D.
2. At time t=1, Dell Networking OS receives an ARP request for IP A.B.C.D.
3. At time t=2, Dell Networking OS installs an ARP entry for A.B.C.D only on RP2.
Beginning with Dell Networking OS version 8.3.1.0, when a gratuitous ARP is
received, Dell Networking OS installs an ARP entry on all three CPUs.
arp max-entries
Enables you to configure the maximum number of ARP entries per VRF that are allowed for IPv4..
S4820T
Syntax
arp max-entries [vrf vrf-name] max-number
Parameters
vrf vrf-name Enter the name of a specific VRF for which you want to
configure maximum number of ARP entries that IPv4 allows.
max-number Enter the maximum number of ARP entries that a VRF RTM
can hold. The range is from 0 to 65535.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
894
IPv4 Routing