Filter
Top Products
Usage
Information
For the new settings to take effect, save the new CAM settings to the startup-
config (write-mem or copy run start) then reload the system.
The total amount of space allowed is 16 FP Blocks. System flow requires three
blocks and these blocks cannot be reallocated. The ipv4acl profile range is from
1 to 4.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.
Ranges for the CAM profiles are from 1 to 10, except for the ipv6acl profile which
is from 0 to 10. The ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).
If you enabled BMP, to perform a reload on the chassis to upgrade any
configuration changes that have changed the NVRAM content, use the reload
conditional nvram-cfg-change command.
cam-acl-vlan
Specify the number of VFP blocks allocated to OpenFlow.
Syntax
cam-acl-vlan vlanopenflow {0|1}
Defaults Disabled.
Parameters
vlanopenflow Enter the number 1 to allocate VFP blocks and enable
OpenFlow.
(Default) Enter the number 0 to disable OpenFlow.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.1.(0.0) Introduced on S4810.
8.3.19.0 Introduced on the S4820T.
Usage
Information
Reboot the switch after changing the parameter values for changes to take effect.
106
Control and Monitoring