Filter
Top Products
match {external
| internal}
(OPTIONAL) The command used for OSPF to route and
redistribute into other routing domains. The values are
• internal
• external
route-map
map-name
map-name is an identifier for a configured route map. The
route map should filter imported routes from the source
routing protocol to the current routing protocol.
If you do not specify a map-name, all routes are
redistributed. If you specify a keyword, but fail to list route
map tags, no routes are imported.
Defaults Refer to Parameters.
Command
Modes
• ROUTER ISIS (for IPv4)
• CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.12.0 Introduced on the S4810.
7.5.1.0 Added support for IPv6 ISIS.
6.3.1.0 Introduced.
Usage
Information
How a metric value assigned to a redistributed route is advertised depends on how
on the configuration of the metric-style command. If the metric-style
command is set for Narrow mode and the metric value in the redistribute
ospf command is set to a number higher than 63, the metric value advertised in
LSPs is 63. If the metric-style command is set for wide mode, the metric value
in the
redistribute ospf command is advertised.
1078
Intermediate System to Intermediate System (IS-IS)