Filter
Top Products
Parameters
level Indicate a value from 0 to 7 or enter one of the following
parameters: emergencies, alerts, critical, errors,
warnings, notifications, informational, or
debugging. The default is 7 or debugging.
Defaults 7 or debugging
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Related
Commands
default logging monitor — returns the logging monitor parameters to the default
setting.
logging on
Specify that debug or error messages are asynchronously logged to multiple destinations, such as the
logging buffer, Syslog server, or terminal lines.
Syntax
logging on
To disable logging to logging buffer, Syslog server and terminal lines, use the no
logging on
command.
Defaults Enabled.
Simple Network Management Protocol (SNMP) and Syslog
1731