Dell 9.8(0.0) Network Router User Manual


  Open as PDF
of 1910
 
Parameters
id Enter the S-Series stack unit ID. The unit ID range is from 0
to 11 for the S4820T.
vrf vrf-name Enter the keyword vrf followed by the name of the VRF to
view FIB entries corresponding to that VRF.
ip-address
mask
(OPTIONAL) Enter the IP address of the network destination
to view only information on that destination. Enter the IP
address in dotted decimal format (A.B.C.D). Enter the mask in
slash prefix format (/X).
longer-prefixes (OPTIONAL) Enter the keywords longer-prefixes to view
all routes with a common prefix.
summary (OPTIONAL) Enter the keyword summary to view the total
number of prefixes in the FIB.
Command
Modes
EXEC
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Added support for VRF.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Added support for up to seven stack members.
7.6.1.0 Introduced on the S-Series.
Usage
Information
The following describes the show ip fib stack-unit command shown in the
following example.
Field Description
Destination Lists the destination IP address.
Gateway Displays either the word “direct” and an interface for a
directly connected route or the remote IP address used to
forward the traffic.
First-Hop Displays the first hop IP address.
IPv4 Routing
951