Filter
Top Products
logging synchronous
Synchronize unsolicited messages and Dell Networking OS output.
Syntax
logging synchronous [level level | all] [limit number-of-
buffers]
To disable message synchronization, use the no logging synchronous [level
level | all] [limit number-of-buffers] command.
Parameters
all Enter the keyword all to ensure that all levels are printed
asynchronously.
level level Enter the keyword level then a number as the severity
level. A high number indicates a low severity level and vice
versa. The range is from 0 to 7. The default is 2.
all Enter the keyword all to turn off all.
limit number-
of-buffers
Enter the keyword limit then the number of buffers to be
queued for the terminal after which new messages are
dropped. The range is from 20 to 300. The default is 20.
Defaults Disabled. If enabled without the level or number-of-buffers options specified,
level =
2 and number-of-buffers = 20 are the defaults.
Command
Modes
LINE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
1734
Simple Network Management Protocol (SNMP) and Syslog