Dell 9.8(0.0) Network Router User Manual


  Open as PDF
of 1910
 
00:00:5e:00:01:14
Virtual IP address:
10.0.0.2
Authentication: (none)
Dell#show vrrp vrf jay brief
Interface Group Pri Pre State Master addr Virtual
addr(s) Description
---------------------------------------------------------------
-----------------------------------
Te 1/0 IPv4 20 100 Y Master 10.0.0.3 10.0.0.2
Dell#
track
Monitor an interface and lower the priority value of the VRRP group on that interface if it is disabled.
Syntax
track interface [priority-cost cost]
To disable monitoring, use the no track interface command.
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or
number information:
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
For Port Channel interface types, enter the keywords
port-channel then a number.
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
For a VLAN interface, enter the keyword vlan followed
by the VLAN ID. The VLAN ID range is from 1 to 4094.
priority-cost (OPTIONAL) Enter a number as the amount to be subtracted
from the priority value. The range is 1 to 254. The default is
10.
Defaults priority cost = 10
Command
Modes
VRRP
Command
History
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
7.6.1.0 Introduced on the S-Series (S50 only).
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Virtual Router Redundancy Protocol (VRRP)
1899