Filter
Top Products
43
Port Monitoring
The port monitoring feature allows you to monitor network traffic by forwarding a copy of each
incoming or outgoing packet from one port to another port.
Important Points to Remember
• Port monitoring is supported on physical ports and logical interfaces, such as port channels and
virtual local area networks (VLANs).
• The monitoring (destination, “MG”) and monitored (source, “MD”) ports must be on the same switch.
• In general, a monitoring port should have no ip address and no shutdown as the only
configuration; Dell Networking OS permits a limited set of commands for monitoring ports; display
them using the
? command. A monitoring port also may not be a member of a VLAN.
• A total of 4 MG may be configured in a single port-pipe.
• MG and MD ports can be reside anywhere across a port-pipe.
• The Dell Networking OS supports multiple source ports to be monitored by a single destination port
in one monitor session.
• One monitor session can have only one MG port.
NOTE: The monitoring port should not be a part of any other configuration.
description
Enter a description of this monitoring session.
Syntax
description {description}
To remove the description, use the no description {description}
command.
Parameters
description Enter a description regarding this session (80 characters
maximum).
Defaults none
Command
Modes
CONFIGURATION
Port Monitoring
1425