Filter
Top Products
Version Description
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Introduced on the C-Series for the port-channels and the S-
Series.
7.7.1.1 Introduced
Usage
Information
This command configures an expiration timer for all S.G entries, unless they are
assigned to an Extended ACL.
Even though the FHR nodes act as RPs, these nodes still send Register encap
messages to themselves and expect to receive a Register stop message (for
Anycast RP support). As a result, if the DLT timer expires, SG is not deleted until the
register state is deleted in the node. This register state expires 210 seconds after
the last Null register is received.
ip pim ssm-range
Specify the SSM group range using an access list.
Syntax
ip pim [vrf vrf-name] ssm-range {access_list_name}
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to specify the SSM group range for that VRF.
NOTE: Applies to specific VRF if input is provided, else
applies to Default VRF.
access_list_na
me
Enter the name of the access list.
Defaults Default SSM range is 232/8 and ff3x/32
Command
Modes
CONFIGURATION
Command
History
Version Description
9.7(0.0) Introduced on the S6000-ON. Added support for VRF on
S6000, S4810, S4820T, Z9000, Z9500, and S6000–ON.
9.7(0.0) Added support for VRF.
9.5(0.1) Introduced on the Z9500.
1406
PIM-Sparse Mode (PIM-SM)