Filter
Top Products
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Related
Commands
forward-delay — changes the wait time before STP transitions to the Forwarding
state.
hello-time — changes the time interval between BPDUs.
protocol spanning-tree
To enable and configure the spanning tree group, enter SPANNING TREE mode.
Syntax
protocol spanning-tree stp-id
To disable the Spanning Tree group, use the no protocol spanning-tree
stp-id command.
Parameters
stp-id Enter zero (0). Dell Networking OS supports one spanning
tree group, group 0.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
1776
Spanning Tree Protocol (STP)