Filter
Top Products
37
Multicast
The multicast commands are supported by Dell Networking operating system (OS) on all S4820T
platform.
This chapter contains the following sections:
• IPv4 Multicast Commands
IPv4 Multicast Commands
The following section contains the IPv4 multicast commands.
clear ip mroute
Clear learned multicast routes on the multicast forwarding table. To clear the protocol-independent
multicast (PIM) tree information base, use the
clear ip pim tib command.
S4820T
Syntax
clear ip mroute [vrf vrf-name] {group-address [source-address]
| * | snooping}
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to configure this setting on that VRF.
NOTE: Applies to specific VRF if input is provided, else
applies to Default VRF.
group-address
[source-
address]
Enter the multicast group address and source address (if
desired), in dotted decimal format, to clear information on a
specific group.
* Enter * to clear all multicast routes.
snooping Enter the keyword snooping to delete multicast snooping
route table entries.
Command
Modes
EXEC Privilege
Multicast
1213