Filter
Top Products
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added ipv6 support.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
To remove all configured debug commands for BGP, enter the no debug ip bgp
command.
debug ip bgp soft-reconfiguration
Enable soft-reconfiguration debug.
S4820T
Syntax
debug ip bgp [vrf vrf-name] [A.B.C.D | X:X:X:X::X | peer-group-
name] soft-reconfiguration
To disable, use the debug ip bgp [vrf vrf-name] [A.B.C.D |
X:X:X:X::X | peer-group-name] soft-reconfiguration command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to enable soft-reconfiguration debugging on that
VRF.
A.B.C.D (OPTIONAL) Enter the IPv4 address of the neighbor in dotted
decimal format.
X:X:X:X::X (OPTIONAL) Enter an IPv6 address.
peer-group-
name
(OPTIONAL) Enter the name of the peer group to disable or
enable all routers within the peer group..
Defaults Disabled
Border Gateway Protocol
439