Dell 9.8(0.0) Network Router User Manual


  Open as PDF
of 1910
 
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
For a port channel interface, enter the keywords port-
channel
then a number. The range is from 1 to 128.
For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Defaults Not configured.
Command
Modes
ROUTER ISIS
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
Usage
Information
Although the passive interface does not send nor receive routing updates, the
network on that interface is still included in the IS-IS updates sent using other
interfaces.
redistribute
Redistribute routes from one routing domain to another routing domain.
Syntax
redistribute {static | connected | rip} [level-1 | level-1-2 |
level-2] [metric metric-value] [metric-type {external |
internal}] [route-map map-name]
To end redistribution or disable any of the specified keywords, use the no
redistribute {static | connected | rip} [metric metric-value]
[metric-type {external | internal}] [level-1 | level-1-2 |
level-2] [route-map
map-name] command.
Intermediate System to Intermediate System (IS-IS)
1073