Filter
Top Products
• 30 hops max
• 40 byte packet size
• UDP port = 33434
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.2.1.0 Introduced on the E-Series ExaScale with IPv6.
8.1.1.0 Introduced on the E-Series ExaScale (IPv4 only).
7.9.1.0 Introduced VRF.
7.6.1.0 Added support for the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Added support for IPv6 address on the E-Series.
E-Series Original command.
Usage
Information
When you enter the traceroute command without specifying an IP address
(Extended Traceroute), you are prompted for a target and source IP address,
timeout (in seconds) (default is
5), a probe count (default is 3), minimum TTL
(default is 1), maximum TTL (default is 30), and port number (default is 33434). To
keep the default setting for those parameters, press the ENTER key.
For IPv6, you are prompted for a minimum hop count (default is 1) and a maximum
hop count (default is 64).
Example (IPv4)
Dell#traceroute www.Dell Networking.com
Translating "www.Dell Networking.com"...domain server
(10.11.0.1) [OK]
Type Ctrl-C to abort.
-----------------------------------------------
Tracing the route to www.Dell Networking.com (10.11.84.18),
30 hops max, 40 byte packets
Control and Monitoring
177