Filter
Top Products
show feature
Verify the status of software applications, such as VRF, that are activated and running on a device.
S4820T
Syntax
show feature
Command
Modes
EXEC
EXEC Privilege
Command
History
Version 9.4(0.0) Introduced on the S4810, S4820T, and S6000.
Usage
Information
You can activate VRF application on a device by using the feature vrf command
in CONFIGURATION mode. The no feature vrf command is not supported on
any of the platforms.
Example
Dell#show feature
Feature State
------------------------------
VRF enabled
Command Modes
To navigate and launch various CLI modes, use specific commands. Navigation to these modes is
described in the following sections.
BGP ADDRESS-FAMILY Mode
To enable or configure IPv4 for BGP, use BGP ADDRESS-FAMILY mode. For more information, refer to
Border Gateway Protocol IPv4 (BGPv4).
To enable or configure IPv6 for BGP, use BGP ADDRESS-FAMILY mode.
To enter BGP ADDRESS-FAMILY mode:
1. Verify that you are logged in to ROUTER BGP mode.
2. Enter the command address-family
3. Enter the protocol type.
• For IPv4, enter ipv4 multicast. The prompt changes to include (conf-router_bgp_af) for IPv4.
• For IPv6, enteripv6 unicast. The prompt changes to include (conf-router_bgpv6_af) for IPv6.
CLASS-MAP Mode
To create or configure a class map, use CLASS-MAP mode. For more information, refer to Policy-Based
QoS Commands.
CLI Basics
53