Filter
Top Products
Usage
Information
You can configure priorities independently for Level 1 and Level 2. Priorities
determine which router on a LAN is the designated router. Priorities are advertised
within hellos. The router with the highest priority becomes the designated
intermediate system (DIS).
NOTE: Routers with a priority of 0 cannot be a designated router.
Setting the priority to 0 lowers the chance of this system becoming the DIS, but
does not prevent it. If all the routers have priority 0, one with highest MAC address
becomes DIS even though its priority is 0.
is-type
Configure IS-IS operating level for a router.
Syntax
is-type {level-1 | level-1-2 | level-2-only}
To return to the default values, use the no is-type command.
Parameters
level-1 Allows a router to act as a Level 1 router.
level-1-2 Allows a router to act as both a Level 1 and Level 2 router.
This setting is the default.
level-2-only Allows a router to act as a Level 2 router.
Defaults level-1-2
Command
Modes
ROUTER ISIS
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
1062
Intermediate System to Intermediate System (IS-IS)