Dell 9.8(0.0) Network Router User Manual


  Open as PDF
of 1910
 
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
snmp-server enable traps
Enable SNMP traps.
Syntax
snmp-server enable traps [notification-type] [notification-
option]
To disable traps, use the no snmp-server enable traps [notification-
type] [notification-option] command.
Parameters
notification-
type
Enter the type of notification from the following list:
bgp — Notification of changes in the BGP process.
config — Notification of changes to the startup or
running configuration.
ecfm — Notification of changes to ECFM.
ecmp — Enable an ECMP trap to notify of ECMP or link
bundle traffic imbalances.
envmon — For Dell Networking device notifications when
an environmental threshold is exceeded.
isis — Notification of intermediate service traps.
lacp — Notification of changes.
snmp — Notification of RFC 1157 traps.
stp — Notification of a state change in the spanning tree
protocol (RFC 1493).
vlt — Notification of virtual link trunking.
vrrp — Notification of a state change in a VRRP group.
xstp — Notification of a state change in MSTP (802.1s),
RSTP (802.1w), and PVST+.
notification-
option
For the envmon notification-type, enter one of the following
optional parameters:
1700
Simple Network Management Protocol (SNMP) and Syslog