Dell 9.8(0.0) Network Router User Manual


  Open as PDF
of 1910
 
To return to the default values, use the no distribute-list prefix-list-
name out [bgp as number connected | ospf process-id | rip |
static] command.
Parameters
prefix-list-
name
Specify the prefix list to filter prefixes in routing updates.
connected (OPTIONAL) Enter the keyword connected for directly
connected routing process.
ospf process-id (OPTIONAL) Enter the keyword ospf then the OSPF
process-ID number. The range is from 1 to 65535.
bgp as number (OPTIONAL) Enter the BGP then the AS Number. The range is
from 1 to 65535.
rip (OPTIONAL) Enter the keyword rip for RIP routes.
static (OPTIONAL) Enter the keyword static for user-configured
routing process.
Defaults Not configured.
Command
Modes
ROUTER ISIS (for IPv4)
CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
7.5.1.0 Added IPv6 ISIS support.
6.3.1.0 Introduced.
Usage
Information
You can assign a name to a routing process so a prefix list IS applied to only the
routes derived from the specified routing process.
Related
Commands
distribute-list in — filters the networks received in updates.
redistribute — redistributes routes from one routing domain to another routing
domain.
1040
Intermediate System to Intermediate System (IS-IS)