Filter
Top Products
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Defaults All interfaces in Layer 2 mode are untagged.
Command
Modes
INTERFACE VLAN
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.1 Introduced on the E-Series.
Usage
Information
When you use the no tagged command, the interface is automatically placed in
the Default VLAN as an untagged interface unless the interface is a member of
another VLAN. If the interface belongs to several VLANs, remove it from all VLANs
to change it to an untagged interface.
Tagged interfaces can belong to multiple VLANs, while untagged interfaces can
only belong to one VLAN at a time.
Related
Commands
interface vlan — configures a VLAN.
untagged — specifies which interfaces in a VLAN are untagged.
track ip
Track the Layer 3 operational state of a Layer 3 VLAN, using a subset of the VLAN member interfaces.
S4820T
Syntax
track ip interface
1132
Layer 2