Filter
Top Products
Version Description
8.1.1.0 Introduced on the E-Series ExaScale.
7.5.1.0 Introduced on the C-Series.
7.6.1.0 Introduced on the E-Series
Usage
Information
If you disable auto failover, enter the redundancy auto-failover-limit
(without any parameters) to set auto failover to the default parameters (Count 3,
Period 60 minutes). To view the redundancy status, use the show redundancy
command.
When you change one or both of the optional parameters, Dell Networking OS
checks that the interval between auto failovers is more than five (5) minutes. If the
interval is less, Dell Networking OS returns a configuration error message.
redundancy disable-auto-reboot
Prevent the system from auto-rebooting the failed module.
S4820T
Syntax
redundancy disable-auto-reboot stack-unit [0–11 | members}
[rpm| card number | all]
To return to the default, use the no redundancy disable-auto-reboot
stack-unit rpm
command.
Parameters
rpm Enter the keyword rpm to disable auto-reboot of the failed
RPM.
stack-unit Enter the keyword stack-unit then the stack-unit ID
number.
Default Disabled (that is, the failed module is automatically rebooted).
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
High Availability (HA)
747