Filter
Top Products
show ip ospf topology
Display routers in directly connected areas.
S4820T
Syntax
show ip ospf [process-id | vrf vrf-name] topology
Parameters
process-id Enter the OSPF Process ID to show a specific process. If no
Process ID is entered, command applies only to the first
OSPF process.
vrf vrf-name Enter the keyword vrf followed by the name of the VRF to
information on routers corresponding to a specific VRF that
are in directly connected areas.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.4.(0.0) Added support for VRF.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Added support for Multi-Process OSPF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series and E-Series.
Usage
Information
To isolate problems with inter-area and external routes, use this command. In
OSPF inter-area and external routes are calculated by adding LSA cost to the cost
of reaching the router. If an inter-area or external route is not of correct cost, the
display can determine if the path to the originating router is correct or not.
Example
Dell#show ip ospf 1 topology
Router ID Flags Cost Nexthop Interface Area
3.3.3.3 E/B/-/ 1 20.0.0.3 Gi 13/1 0
Open Shortest Path First (OSPFv2 and OSPFv3)
1339