Filter
Top Products
Version Description
9.0.2.0 Introduced on the S6000.
8.3.11.1 Introduced on the Z9000.
8.2.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the C-Series and S-Series.
Usage
Information
You must enable the stackable VLAN (using the vlan-stack compatible
command) on the VLAN prior to adding a member to the VLAN.
Related
Commands
vlan-stack compatible — enables stackable VLAN on a VLAN.
stack-unit stack-group
Configure a stacking group specified by an ID.
Syntax
[no] stack-unit unit-id stack-group stack-group-id
Parameters
unit-id Enter the stack unit ID.
stack-group-id Enter the stack group ID. The range is from 0 to 16.
[no] Use no stack-unit unit-id stack-group stack-id
to remove the current stack group configuration.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.10.2 Introduced on the S4810.
1834
VLAN Stacking