Dell 9.8(0.0) Network Router User Manual


  Open as PDF
of 1910
 
Version Description
7.8.1.0 Introduced on the C-Series. Increased the name string to
accept up to 140 characters. Prior to version 7.8.1.0, names
are up to 16 characters long.
7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
The number of entries allowed per ACL is hardware-dependent. For detailed
specification on entries allowed per ACL, refer to your line card documentation.
You can create an IPv6 ACL for control-plane traffic policing for OSPFv3, in
addition to the CoPP support for VRRP, BGP, and ICMP.
cam-acl-egress
Allocate space for IPv6 egress ACLs.
S4820T
Syntax
cam-acl-egress {default | l2acl 1-4 ipv4acl 1-4 ipv6acl 0-4}
Parameters
default Use the default CAM profile settings, and set the CAM as
follows:
L2 ACL(l2acl): 1
L3 ACL (ipv4acl: 1
IPv6 L3 ACL (ipv6acl): 2
l2acl 1-4
ipv4acl 1- 4
ipv6acl 0-4
Allocate space to support IPv6 ACLs. Enter all of the profiles
and a range. Enter the CAM profile name then the amount to
be allotted. The total space allocated must equal 4. The
ipv6acl range must be a factor of 2.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
982
IPv6 Access Control Lists (IPv6 ACLs)