Filter
Top Products
max-number Enter the maximum number of protocol routes that a VRF
RTM can hold. The range is from 0 to 7500.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Introduced on the S4810 and S4820T.
Usage
Information
Use this command to specify the maximum number of protocol routes that the
Route Table Manager can hold for a specific VRF. This command does not apply to
the management VRFs.
Related
Commands
show ip route — views the switch routing table.
show ipv6 route — displays the IPv6 routes.
ip mtu
Set the IP MTU (frame size) of the packet the RPM transmits for the line card interface. If the packet must
be fragmented, Dell Networking OS sets the size of the fragmented packets to the size specified in this
command.
S4820T
Syntax
ip mtu value
To return to the default IP MTU value, use the no ip mtu command.
Parameters
value Enter the maximum MTU size if the IP packet is fragmented.
The range is from 576 to 9234. The default is 1500 bytes.
Defaults 1500 bytes
Command
Modes
INTERFACE (Gigabit Ethernet and 10-Gigabit Ethernet interfaces)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
922
IPv4 Routing