Filter
Top Products
Parameters
host Enter the keyword host to set the device-role as host.
router Enter the keyword router to set the device-role as router.
Defaults none
Command
Modes
POLICY LIST CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, and
Z9000 switches.
Related
Commands
• ipv6 nd raguard policy policy-name — Defines the RA guard policy name and
enter the RA guard policy configuration mode.
• ipv6 nd ra-guard enable — Allows you to configure the RA guard related
commands.
hop-limit
Enable the verification of the advertised hop count limit. If this command is not configured, the
verification process is bypassed.
Syntax
hop-limit {maximum | minimum limit}
To reset the hop count limit, use the no hop-limit {maximum | minimum
limit} command.
Parameters
maximum limit Enter the keyword maximum then the hop limit value. The
range is from 0 to 254.
minimum limit Enter the keyword minimum then the hop limit value. The
range is from 0 to 254.
Defaults none
Command
Modes
POLICY LIST CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1228
Neighbor Discovery Protocol (NDP)