Filter
Top Products
AS-Path Commands
The following commands configure AS-Path ACLs.
ip as-path access-list
Enter AS-PATH ACL mode and configure an access control list based on the BGP AS_PATH attribute.
Syntax
ip as-path access-list as-path-name
Parameters
as-path-name Enter the access-list name, up to 140 characters.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names are up to 16 characters long.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
To apply the AS-PATH ACL to BGP routes, use the match as-path or neighbor
filter-list commands.
Example
Dell(conf)#ip as-path access-list TestPath
Dell(config-as-path)#
Related
Commands
match as-path — matches on routes contain a specific AS-PATH.
Access Control Lists (ACL)
319