Filter
Top Products
set ip dscp Configures the Differentiated Services Code Point (DSCP)
value of the packets in the Encapsulated Remote Switched
Port Analyzer (ERSPAN) traffic. To revert to the default value,
use the no form of this command.
dscp_value DSCP value of the packets in the ERSPAN traffic. The range is
from 0 to 63. The default value is 0.
set ip ttl Configures the IP time-to-live (TTL) value of the
Encapsulated Remote Switched Port Analyzer (ERSPAN)
traffic. To revert to the default configuration, use the no form
of this command.
ttl_value IP TTL value of the ERSPAN traffic. The range is from 1 to
255. The default value is 255.
drop Monitors only the dropped packets in the Ingress.
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Added the drop parameter.
9.7(0.0) Introduced on the S6000-ON. Introduced the set ip
dscp and set ip ttl parameters.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
9.0.2.0 Introduced on the S6000.
9.0.2.0 Introduced on the MXL.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage
Information
The monitor command is saved in the running configuration at Monitor Session
mode level and can be restored after a chassis reload.
Example
Dell#show monitor session
SessID Source Destination Dir Mode Source
IP Dest IP DSCP TTL
------ ------ ----------- --- ----
--------- -------- ---- ---
0 Te 1/12 remote-ip rx Flow
1.1.1.1 7.1.1.2 0 255
0 Po 1 remote-ip tx Flow
1.1.1.1 7.1.1.2 0 255
Port Monitoring
1427