Filter
Top Products
4
Control and Monitoring
This chapter contains the commands to configure and monitor the system, including Telnet, file transfer
protocol (FTP), and trivial file transfer protocol (TFTP).
NOTE: This command replaces the enable optic-info-update interval command to
update information on temperature and power monitoring in the simple network management
protocol (SNMP) management information base (MIB).
asf-mode
Enable alternate store and forward (ASF) mode and forward packets as soon as a threshold is reached.
Syntax
asf-mode stack-unit {unit-id | all} queue size
To return to standard Store and Forward mode, use the no asf-mode stack
unit command.
Parameters
unit-id Enter the stack member unit identifier of the stack member
to reset. The S4820T range is from 0 to 11.
NOTE: The S4820T commands accept Unit ID numbers
from 0 to 11, though S4820T supports stacking of up to
six units.
queue size Enter the queue size of the stack member. The range is from
0 to 15.
Defaults Not configured
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
Control and Monitoring
99