Filter
Top Products
Version Description
8.2.1.0 Introduced on the S-Series.
7.8.1.0 Introduced on the C-Series.
Usage
Information
Save the new CAM settings to the startup-config (write-mem or copy run
start
) then reload the system for the new settings to take effect.
The total amount of space allowed is 16 FP Blocks. System flow requires three
blocks; these blocks cannot be reallocated. Only 13 number of blocks can be
configured by the user .
There can be only one odd number of Blocks in the CLI configuration; the other
Blocks must be in factors of 2. For example, a CLI configuration of 5+4+2+1+1
Blocks is not supported; a configuration of 6+4+2+1 Blocks is supported.
The ipv6acl allocation must be a factor of 2.
If allocation values are not entered for the CAM regions, the value is 0.
If you enable BMP, to perform a reload on the chassis to upgrade any configuration
changes that have changed the NVRAM content, use the command reload
conditional nvram-cfg-change
.
cam-acl-egress
Allocate CAM for egress ACLs.
S4820T
Syntax
cam-acl-egress default | l2acl number ipv4acl number ipv6acl
number
Parameters
default Reset egress CAM ACL entries to default settings.
l2acl number Allocate space to each CAM region. The total space
allocated must equal 4. The ipv6acl range must be a factor of
2.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command..
Version Description
9.7(0.0) Introduced on the S6000–ON.
Content Addressable Memory (CAM)
543