Filter
Top Products
• To disable IGMP debugging, use the no debug ip igmp [vrf vrf-name]
[group address | interface] command.
• To disable all debugging, use the undebug all command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to enable debugging of IGMP packets corresponding
to that VRF.
NOTE: Applies to specific VRF if input is provided, else
applies to Default VRF.
group-address (OPTIONAL) Enter the IP multicast group address in dotted
decimal format.
interface
interface
Enter the following keywords and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a port channel interface, enter the keywords port-
channel
then a number.
Defaults Disabled.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Internet Group Management Protocol (IGMP)
763