Filter
Top Products
Dell(conf-if-autoneg)#mode ?
forced-master Force port to master mode
forced-slave Force port to slave mode
Dell(conf-if-autoneg)#
Example
(Configured)
Dell#show interfaces configured
TenGigabitEthernet 13/18 is up, line protocol is up
Hardware is Force10Eth, address is 00:01:e8:05:f7:fc
Current address is 00:01:e8:05:f7:fc
Interface index is 474791997
Internet address is 1.1.1.1/24
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 1000 Mbit, Mode full duplex, Master
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interfaces" counters 00:12:42
Queueing strategy: fifo
Input Statistics:
...
User
Information
Both sides of the link must have auto-negotiation enabled or disabled for the link
to come up.
The following details the possible speed and auto-negotiation combinations for a
line between two 10/100/1000 Base-T Ethernet interfaces.
Port 0
• auto-negotiation enabled* speed 1000 or auto
• auto-negotiation enabled speed 100
• auto-negotiation disabled speed 100
• auto-negotiation disabled speed 100
• auto-negotiation enabled* speed 1000 or auto
Port 1
• auto-negotiation enabled* speed 1000 or auto
• auto-negotiation enabled speed 100
• auto-negotiation disabled speed 100
• auto-negotiation enabled speed 100
• auto-negotiation disabled speed 100
Link Status Between Port 1 and Port 2
• Up at 1000 Mb/s
• Up at 100 Mb/s
• Up at 100 Mb/s
• Down
• Down
* You cannot disable auto-negotiation when the speed is set to 1000 or auto.
814
Interfaces