Dell 9.8(0.0) Network Router User Manual


  Open as PDF
of 1910
 
source port ID fields to hash. The hashing mechanism
returns a 3-bit index indicating which port the packet
should be forwarded.
source-mac — Uses the source MAC address, VLAN,
Ethertype, source module ID and source port ID fields to
hash. The hashing mechanism returns a 3-bit index
indicating which port the packet should be forwarded.
tcp-udp enable Enter the keywords to distribute traffic based on the
following:
enable — Takes the TCP/UDP source and destination
ports into consideration when doing hash computations.
This option is enabled by default.
ingress-port
enable
Enter the keywords to distribute traffic based on the
following:
enable — Takes the source port into consideration when
doing hash computations. This option is disabled by
default.
Defaults IP 4-tuple (IP SA, IP DA, Source Port, Destination Port)
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.0 Added the ingress-port parameter for the S4810.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage
Information
By default, Dell Networking OS distributes incoming traffic based on a hash
algorithm using the following criteria:
IP source address
IP destination address
TCP/UDP source port
IPv4 Routing
933