Filter
Top Products
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names are up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage
Information
Dell Networking OS supports one ingress and one egress MAC ACL per interface.
The number of entries allowed per ACL is hardware-dependent. For detailed
specifications about entries allowed per ACL, refer to your line card
documentation.
NOTE: Ingress ACLs are supported on C-Series and S-Series platforms only.
Example
Dell(conf)#mac-access-list access-list standard TestMAC
Dell(config-std-macl)#permit 00:00:00:00:00:00
00:00:00:00:ff:ff count
Dell(config-std-macl)#deny any count
permit
To forward packets from a specific source MAC address, configure a filter.
Syntax
permit {any | mac-source-address [mac-source-address-mask]}
[count [byte]] | [log] [monitor]
To remove this filter, you have two choices:
• Use the no seq sequence-number command if you know the filter’s
sequence number.
• Use the no permit {any | mac-source-address mac-source-
address-mask} command.
Parameters
any Enter the keyword any to forward all packets received with a
MAC address.
Access Control Lists (ACL)
271